Manual - Yeastar

Yeastar logo.png
General informationWe advice you to click here for the Yeastar manual.Configuration in partner portalTo connect the Yeastar telephony system to Bubble with the Yeastar connector, it is necessary to ad...

Index

General information

Configuration in partner portal

Configuration in the Yeastar admin portal

Configuration in Bubble Software

Features

Pop-up type

Bubble pop-up
Make use of the pop-up that Bubble triggers by incoming calls.


Call control

Answer button
With call control you can directly answer a call via a button in the pop-up notification.

Hangup button
With call control you can directly end a call via a button in the pop-up notification.

Call initiation
Call initiation is supported by this integration. That means that you can easily start an outgoing telephone call with one mouse click (click to dial), dial button on your keybord (select to dial) or use the Bubble remote dialer and SearchBar.

Hold/Resume button
Easily put a call on hold during a call with a single mouse click

Cold transfer button
The cold transfer feature allows you to transfer the call directly to a phone number without a callback.

Attended transfer button
The warm transfer feature allows you to transfer the call to a call-back telephone number.


Call Events

Inbound events
This allows Bubble to show data for incoming calls.

Outbound events
This allows Bubble to show data for outgoing calls.

Transfered events
Bubble also displays the data on transferred calls.


Integration type

Company based
This telephone system supports company-level authentication. It is only necessary to add the internal phonenumbers/extensions to the user(s) in the partner portal.


In general it can have four causes:Cause 1The phone connector is not active yet in Bubble. Make sure you double click on the phone connector so there is a blue frame around it. Only then is the Phone...

Log in if you want to read further

Index

Cause 1

Cause 2

Cause 3

Cause 4

Yes, you can! In the Bubble software you can check under Phone Connectors if the call events are coming through. This is also an extra way of checking whether you have done the configuration correctly...

Log in if you want to read further

Note: This item applies to all phone connectors that are routing call events based on the users internal number.You can configure the default Click&Call device by marking the user's internal numbe...

Log in if you want to read further

Copyright Red Cactus B.V. © 2020 - 2024 Terms and conditions